Razor Ribbon barbed tape is engineered for consistency in structure and material composition,
and conforms to federal, state, and industrial specifications. All
barbed tape products are manufactured from exceptionally tough,
high quality stainless steel components. Razor Ribbon barbed tape
is available in single coil and single or double coil concertina.
It is specifically designed to provide maximum perimeter security
for a wide variety of applications.
Razor ribbon is one of our major razor wire strip products. We
manufacture two types of razor wire ribbons - Galvanized &
Stainless Steel. The loops are normally not clipped together in
concertina fashion. This allows the razor wire coil to be installed
in any distance between loops, depending on the security desired,
the most common being 18" or 450mm.
Razor wire ribbon is a kind of galvanized steel wire tape, with
two-sided blades with symmetrical arrangement. The galvanized steel
wire diameter is of 2.5 millimeters, reinforced to 5mm in diameter.
The most important feature of razor concertina wire is that its construction is able to maintain its structure.
Razor wire ribbon coil is manufactured in 3 diameters - 18" - 24" -
36" (450-600-750 mm). It is fabricated from A 1" (26 mm) wide and
0.020" (0.50 mm) thick strip of G 90 galvanized material or 430
stainless steel. Clusters of 4 needle sharp barbs are located 4"
(100 mm) on center around each coil loop. Each barb is 1.2 when
measured from the center of the cluster. The coil is cold pressed
230o around A 0.091 (2.3 mm) diameter high tensile galvanized or
stainless steel core wire. Galvanized steel wire materials can
operate in an open air temperature of -50 ~ 50 centigrade, and it
can function under the impact of rain, fog, snow, dust and strong
wind loads. The design is very easy to assemble and install,
allowing the repeated use of it, for example, on construction
When ordering the concertina each loop shall be clipped. The
adjacent loop 3- 5 -7 or 9 times equally spaced around the
circumference to provide the concertina effect. The clips are made
of 0.065" × 0.0375 stainless steel capable of withstanding a
minimum pull load of 200 lbs.
|Kinds||Electro galvanized wire|
|Hot galvanized wire|
|PVC coated wire|
|Material||low carbon steel wire|
|Inner plastic and outer hessian cloth|
|Gauge||Gauge||SWG mm||BWG mm||In Metric System mm|